Introduction of Hydraulic Goods Lift

The hydraulic goods lift is a non-scissor hydraulic lifting mechanical equipment. It is used to transfer goods between the second and third floors of industrial plants, restaurants and restaurants. The lower height is 150-350mm, especially suitable for the site where can not dig pit to install the lift. Places, and no upper lifting points, diversified forms (double column, four column, eight column). The equipment runs smoothly. The guide rail of the hydraulic goods lift is generally made of H beam, channel steel, and square pipe welding. The operation is simple and reliable. The transmission is economical and convenient.

Application of Hydraulic Goods Lift

We could customized the goods lift for clients according to the site condition such as the installation space is too narrow. The product has a solid structure, large carrying capacity, stable lifting, simple and convenient installation and maintenance. It is an economical and practical low-floor elevator to replace the ideal cargo conveying equipment. This product is mainly used in explosion-proof enterprises such as chemical industry, high temperature, high pressure, power plant, nuclear industry base and explosives.

Function of Hydraulic Goods Lift

● Larger capacity of 30 tons, multi-point control, interactive interlocking of upper and lower floors, to achieve safe use;
● Multi-point control, interactive interlocking of upper and lower floors, to achieve safe use;
● High lifting height, using side-mounted oil cylinder, or double measuring oil cylinder, stable operation, no noise, convenient maintenance and long service life;
● Manual lowering after power failure, emergency stop button, convenient, fast and practical;
● The depth of the pit is generally 15cm-30cm, and the height of the top layer is not limited, and it can be customized according to the site environment;
● The floor door can be penetrated, and the inside and outside of the workshop can be opened mutually, which is convenient and saves space; it is especially suitable for 2-3 floors of steel structure workshops, both inside and outside;

Product Advantages of Hydraulic Goods Lift

● Low cost
● Low failure rate: Due to the advanced hydraulic system and good control method, the failure rate of elevator operation can be reduced to a low level.
● Low power consumption: When the hydraulic elevator goes down, it is driven by the pressure generated by its own weight, which greatly saves energy.

Civil engineering advantages

● There is no need for a machine room above the hoistway, and the top floor can be installed with a height of 3.5 meters or more.
● The machine room can be located within a 15-meter radius of the hoistway, occupying an area of only 3-4 square meters.
● The hydraulic elevator does not have a counterweight device to improve the utilization rate of the shaft area.
● The hydraulic elevator load and load directly act on the foundation pit through the oil cylinder, and the shaft strength is low. Brick structure or brick concrete structure is enough.

Safety and stability advantages

● Relief valve: can prevent the system pressure from being too high during upward movement
● Emergency manual valve: When the power fails, the car can be dropped to the nearest floor to open the door.
● Manual pump: When the system fails, the manual pump can be operated to pump high-pressure oil to make the car rise to a closer floor position;
● Oil tank oil temperature protection: When the oil temperature in the oil tank exceeds the standard set value, the oil temperature protection device generates a signal to suspend the use of the elevator, and only start the elevator when the oil temperature drops.

Operating cost advantages

● Low failure rate: Due to the use of a good hydraulic system and a good control method, the failure rate of elevator operation can be reduced to a low level.
● Low power consumption: When the hydraulic elevator goes down, it is driven by the pressure generated by its own weight, which greatly saves energy.