Table of Contents
Explanation on the basic operating specifications of the hydraulic cargo elevator lift
The hydraulic cargo elevator lift is mainly used in workshops, warehouses and various working shelves to transport goods up and down: three-dimensional garages and underground garages for car lifting between floors, etc. The hydraulic system of the product is equipped with anti-falling and overload safety protection devices, and operation buttons can be set on each floor and the work surface of the lifting platform to achieve multi-point control. The product has a solid structure, large carrying capacity, stable lifting, simple and convenient installation and maintenance. It is an economical and practical low-floor elevator to replace the ideal cargo conveying equipment.
After the equipment arrives, when unpacking and accepting, check whether the accompanying technical documents are complete, whether the supplied accessories, tools, and accessories are consistent with the list, whether the equipment and accessories are damaged, defective, etc., and make a record of unpacking acceptance.
Compared with ordinary elevators, the operation of such a small lifting platform is somewhat different. The following editor will explain the operating points of the electric elevator in detail.
To operate an electric lift, first check the air obstacles and high-voltage lines before operation. According to the current regulations and standards, the platform should be kept a safe distance from the live high-voltage lines from beginning to end, and must not be crossed. It must work on a solid and level ground, and the load and distribution on the platform must comply with the regulations of the manufacturer. At the same time, the outriggers or stabilizers should be used in accordance with the manufacturer’s instruction manual, and all personnel on the platform should wear seat belts correctly.
Immediately afterwards, turn on the power of the host, install the platform guardrail, carefully check whether there are hidden dangers that affect the on-site operation, pull out the support legs, rotate the support rod to make it support the ground, and then adjust the level of the support legs one by one. But it is not advisable to keep all four wheels off the ground. Observe the level gauge and fine-tune the level of the outriggers. Note: The iron level gauge may be artificially damaged or offset. While adjusting the level, observe the verticality of the telescopic cylinder. Check the level gauge immediately if there is a problem. It is forbidden to start until the problem is solved. Lift the lifting platform. Loosen the clamping screw of the anti-rotation ladder after the cylinder is vertical. Install the clamping screw of the anti-rotation ladder before falling. After the operator gets on the lifting platform, check whether the guardrail screws are firmly connected and fasten the seat belt.
Features of electric lifting platform
1. The structure is compact and stable, which can adapt to high frequency continuous operation.
2. The high stability of lifting, can meet the smooth lifting of large tonnage goods. Equipped with anti-attachment, overload safety protection hydraulic system to ensure safe operation
3. The rising and falling process is uniform and stable.
4. Compact structure, simple appearance, flexible and convenient maintenance and use.
5. The rated load is large, which effectively improves work efficiency.
6. It adopts Italian joint venture pumping station group, with low noise and long service life.
7. A wide range of optional accessories can fully meet customer needs.
8. Clean and pollution-free, conducive to environmental maintenance.
The technology of electric lifting platform is developing faster and faster. The market demand for electric lifting platform is still great, but in order to ensure our safety, we must first understand its operating procedures when using electric lifting platform. Some of the operating experience summarized by the editor of the industry, I hope it will be helpful to you.